User Tools

Site Tools


Sidebar

zactrack manual

[[smart:start]] \\

System Overview
Safety Standards
Hardware Overview
Software Overview
Network
UWB Radiotracking


PREPARATIONS


ZACTRACK SETUP


Hardware


zactrack 3 APP


Autofunctions APP


[[manual:Tracking Server]]\\

zactrack site notice: Homepage

Action disabled: source
manual:define_origin

Define origin on stage

  • Define an origin on stage (coordinate system on stage)

    Note: zactrack uses a right handed cartesian coordinate system.
    X+ and Y+ axis are located on the floor and Z+ axis looks into the ceiling.


    The origin can be chosen freely anywhere on stage. It is recommended to align the X or Y axes parallel to the stage. Usually downstage center is a common origin with an X+ axis orientation towards stage right parallel to the stage. Y+ axis looks upstage and Z-axis looks into the ceiling.



  • Mark the defined origin visible with a sticker or a tape

  • Mark the direction of the positive X-Axis by sticking a tape or a sticker somewhere along the x+ axis.

  • Go to Show Editor and tap Define in the Points Section

  • Tap Disto and aim the laser of the Leica Disto S910 on the marked origin

  • Tap Measure
    Note: Tablet will BEEP after successful measurement

  • Tap Disto and aim the laser of the Leica Disto S910 on the X+ axis mark

  • Tap Measure
    Note: Tablet will BEEP after successful measurement

  • Tap Ok

  • Tap Set
    Note: You'll loose all previous measurements!

  • Now you are ready to Measure Points


manual/define_origin.txt ยท Last modified: 2022/11/10 14:48 by zvonek