User Tools

Site Tools


smart:mount

MOUNT

  1. Mount the 8 anchors around the stage. The positions of the anchors should be as asymmetrical as possible, for good resolution in 3D 4 anchors should be up and 4 down.

  2. Connect the zactrack CORE (Server ETHERNET PORT1) to a network switch

  3. Connect the anchors with a CAT6 cable to a PoE switch within the zacNET
    Note:
    LED on anchor illuminates blue → anchor has power and is connected to tracking server
    LED on anchor red → anchor has power but no connection to tracking server

    Max. length of CAT6 with PoE is 100m. It is possible to extend the range with fiber optic cables


  4. Connect the zactrack CORE (Server ETHERNET PORT2) to the lighting network switch

3D Anchor Setup

All anchors should be mounted around stage on different heights. To get accurate Z-axes positions it is necessary to mount the anchors on multiple Z-levels. Below you will find 2 examples for a 3D anchor setup.

For a 3D position the system picks at least 4 anchors.

Note: You can change the tracking type from 2D to 3D direct on each tracker on the lightconsole

Note: Do not place an anchor directly next to a fixture

2D Anchor Setup

All anchors should be mounted around stage. For 2D anchor setup it is NOT necessary to mount the anchors on multiple Z-levels. Below you will find 2 examples for a 2D anchor setup.

For a 2D position the system picks at least 3 anchors.

This website uses cookies for visitor traffic analysis. By using the website, you agree with storing the cookies on your computer.More information
smart/mount.txt · Last modified: 2020/04/21 09:50 by rosenberg