• Turn on the zactrackPuck with the switch at the bottom.
  
  
• The LED indicates the state (green flashing → connected to network)
  
  
• The zactrackPuck is now ready for fixture alignment
  

Note: If the LED indicates blue continiously → no known wifi network is found and own zactrackPuck WIFI will be enabled. Klick the following link to configuration_of_zactrack_puck_wifi_network

• Setup ip address: 192.168.4.1
• Recommended ip address: 172.20.1.211
• Standard Gateway: 172.20.1.1
• Subnet: 255.255.0.0
  
  

  Configuration of zactrack Puck WIFI network

If the LED shines continous blue search for a zactrackPuck network on your device.

1. Connect your device to the network and wait for a few seconds.
   
   
2. A pop-up brings you to the zactrackPuck config window. (You can type 192.168.4.1 in your browser to go there manually)
   
   
3. Press the Button to scan for availabe networks.
   
4. Choose a network by tapping on it or entering the SSID.
   Put in the password and tap save.
   Note: If your desired network is not shown you can hit the scan button to rescan or enter the SSID and password manually.
   

1. List of all available networks (Standard WIFI → “zactrack”)
   
2. Credentials of chosen network
   
3. zactrack Puck network settings (default settings should remain unchanged)
   

If the configuration succeeded the following dialog comes up: