User Tools

Site Tools


Sidebar

zactrack manual

[[smart:start]] \\

System Overview
Safety Standards
Hardware Overview
Software Overview
Network
UWB Radiotracking


PREPARATIONS


ZACTRACK SETUP


Hardware


zactrack 3 APP


Autofunctions APP


[[manual:Tracking Server]]\\

zactrack site notice: Homepage

manual:tracking_server

Tracking Server

The tracking server is connected to all anchors and its main process is to calculate the real time positions of all active zacTags. These positions will be sent to zactrack CORE which runs simultaneously on the same zactrack SERVER.


Go to Tracking Server

  • Go to Show Editor in the zactrack 3 APP
  • Tap on menu in the top right corner to open the menu
  • Tap on Tracking Server → You will be forwarded to the WebInterface of the Tracking Server


Login

  • Tap on your username and enter your password → password is listed on provided login sheet


System Status

  • Tap on in the top right corner to open the menu
  • Tap on System Status to open the tracking server overview


Overview

The overview shows the following real time information:

  • Primary channel
  • RTLS mode
  • Update Rate [Hz]
  • Active Anchors
  • Active zacTags

The anchor link shows you the radio signal link of each anchor to each other.

Logging

Overrides

### TRACKING SERVER CONFIG LINES

# --> means Comment and is not part of the config line

### INCLUDE ANCHORS
anchor_hubs.eui=XXXXX
network.anchor_ip_eth=10.10.XX.XX

### INCLUDE TRACKERS
sensors.eui=XXXXX

### EXCLUDE ANCHORS
anchor_hubs.eui=!XXXXX

### EXCLUDE TRACKERS
sensors.eui=!XXXXXX

manual/tracking_server.txt · Last modified: 2023/10/31 08:36 by roch